RDV6442G Small Vision Laser Controller for CO2 Laser Engraving Cutting Machine

I've been eyeing this controller since we got our laser cutter with the older 6442 controller. It's so much better because the auto-focus and Z up/down have their own dedicated buttons, rather than having to dive thru a convoluted menu like the older controller had. It wasn't too difficult to upgrade, although the display was slightly wider than our opening and required a little metalwork to fit. My fault for assuming and not checking the measurements beforehand. Copied the old settings off the previous controller and loaded them to this one, tested and adjusted a few settings that seemed to differ and we were off to the races.